My Name is Georg from Germany, and I am new in this forum.
I hope it is welcome to write in English, because I am not very familiar with the Netherlands spelling.
I am finished with the retrofitting of my Emcoturn 120 with EdingCNC about one month ago.
Now I am looking for a parting off tool (left hand of course) with exchangeable blades which fit into the Emcoturn 120.
Does have somebody have a suggestion where I can order a tool like this?
Or does somebody can tell me what blades I need for this tool on the photo?
This tool came along with my lathe.
Thanks in advance
English and probably German is not a problem. But of course you will get more responses of Dutch posts.
You should consider a German forum. I Googled "cnc forum deutschland" and got a lot of hits.
It looks like a holder for SP200 (1.7 mm holder width) or SP300 (2.7 mm holder width) blades.
If so, it is an ZQ2020R alike holder. Just for an impression,
https://www.dennisdeal.com/products/zq2 ... dUQAvD_BwE
You should order a holder that has a shaft suitable for your lathe.
The problem in the German forums is that the Emcoturn is not discussed very much.
Also thanks for the Link, but these tools doesn’t really fit. I think Emcoturn owner know what I mean,
I use this one on my emcoturn120:
https://www.ebay.com/itm/MGEHL1212-2-5- ... 2749.l2649
You need to grind a little off the bottom, and then it just fits.